Model WHSR
Horizontal Lifting, Non-Locking

The Model WHSR is an adjustable, horizontal clamp intended to be used in pairs, sets of pairs, or in a tripod arrangement for transporting steel plates horizontally.

In addition to incorporating two gripping cams, the jaw opening may be adjusted by the positioning of a pin in the body of the clamp. The gripping cams are spring loaded to remain in the "open" position until the load is applied. This feature permits the clamp to be easily applied and removed from the load. Normally furnished with serrated gripping surfaces, it is available with smooth faced bronze or stainless steel surfaces to prevent marring when handling polished plates.

An Application, Operation and Maintenance Manual is packaged with each Renfroe^® product. Repair Kits are also available for most Renfroe^® lifting clamps. We encourage caution when using lifting devices. Refer to the Operating Aids section for important handling information.

Before purchasing refer to General Information Section.